Connect with us

TRAINING & FITNESS

Blast Your Arm Size With This Workout

Whether you want to tone and define weak arms so that you can wear something sleeveless with confidence or you want to increase muscle mass, working the muscles in the front and back of the upper arms will help you get there.

Published

on

Whether you want to tone and define weak arms so that you can wear something sleeveless with confidence or you want to increase muscle mass, working the muscles in the front and back of the upper arms will help you get there.

Most people new to bodybuilding pay a lot of attention to building big arms, sometimes to the point of over-training. Don’t forget, the arm muscles are brought into play during most exercises aimed at other body parts. So care must be taken not to overdo things.

Having said that, the arms are complex body parts in their own right and deserve a properly focused exercise program. In basic terms the arm consists of three main muscle groups:

1. Biceps brachii – two muscles at the front upper arm that run from the elbow to the shoulders.

2. Triceps brachii – three muscles at the rear upper arm that run from the elbow to the shoulder.

3. Forearm – several smaller muscles that run from the elbow to the wrist.

We’re really stuck on wanting to look good and that’s alright, but it’s really one goal of the arm exercise benefits. “Exercise is a body tune-up, and if we’re keeping our body exercised, we’re keeping it tuned just like a car.” When working the arms, be sure to balance the body.

Big arms

We tend to make the mistake of exercising only our show muscles. And that is actually an imbalanced program. We pay too much attention to the muscles in front of our body and not enough attention to the back of the body.

On the most basic level, this doesn’t build the whole muscle.

The reality is, if you want big arms, you’ve got to work both sides of the arms. When someone flexes their biceps, it’s the whole arm that’s working. The triceps are a part of that.

arm exercise barbell curl - Muscle Media

You should vary your grip and width when performing not only these exercises, but all others. Why? Consider the barbell curl as an example. Most guys tend to use a wider grip, which works the short head of the biceps on the inside of the arm, while forgoing a narrow grip, where the biceps’ long head is emphasized. When someone who does this places his hands on his hips, the long head on the outside of his arm is usually small and disproportionate compared to the inner arm. By using the same grip or width all the time, you create an imbalance in size and strength.

Continue Reading

TRAINING & FITNESS

Working The Transverse Ab Muscles

Most abdominal exercises target the rectus abdominus and the vertical abdominals, ignoring the transverse abdominals. Even crunches, the staple of most abdominal workouts, do nothing for the transverse abdominals.

Published

on

abs

A group of muscle mass that usually will get uncared for in abdomen train routines are the transverse abdominals, the core muscle mass that lie under the rectus abdominus. Most stomach workout routines goal the rectus abdominus and the vertical abdominals, ignoring the transverse abdominals. Even crunches, the staple of most stomach exercises, do nothing for the transverse abdominals. These muscle mass are literally crucial to focus onnevertheless, as they connect with each the decrease again muscle mass and the rectus abdominus and for a girdle for all the stomach. Any routine aimed toward flattening the abdomen ought to embrace the transverse abdominals as a spotlightUtilizing the next workout routinesyou may work out your transverse abdominals and actually make progress on that flat tummy. As with all exercise routine, make sure to seek the advice of an expert earlier than starting and at all times heat up correctly to keep away from harm.

This abdomen train requires mendacity in your again on a flat floorreminiscent of the ground or a bench. Use a mat or towel to cushion your backbone. Bend your knees in order that your ft are flat on the groundElevate your pelvis (and solely your pelvis) off the groundmaintain momentarily, after which decrease it again down. Repeat for a whole set. Sustaining a managed motion is essential to this trainThis may will let you use your stomach muscle massslightly than your physique’s momentum, to do the work on the trainAdditionallymake sure to hold your higher physique on the ground all through.

Crunchless Crunch
This primary train is pretty easy however may also be pretty troublesomePrimarily, it includes attempting to tug the stomach button in in the direction of the backboneThis may be difficultbecause it includes utilizing muscle mass which you is probably not used to activating. To beginboth lie or in your abdomen or kneel. You would possibly need to strive each methods and see which helps you are feeling the train higherCalm down your physique as a lot as potential, then attempt to use solely the decrease abdominals to maneuver your stomach button towards your backboneMaintain for ten seconds. If holding for ten seconds feels straightforwardmaintain for an extended interval. The objective is to carry the contraction till you both can not really feel it, otherwise you really feel different muscle mass working tougher than the transverse abdominus. Whenever you really feel this, let the contraction out.

Scissor Kicks

This abdomen train additionally requires mendacity on the groundPlace your arms below your butt, conserving your again pressed towards the ground. Slowly increase one leg to a top of about ten inches, then slowly decrease it again to the ground. As your decrease one leg, increase the opposite. Repeat this movement for a whole set. Sustaining management all through is essential, not permitting momentum to get the higher of you. Your higher physique ought to stay on the ground by way of all the transfer.

There are many different workout routines concentrating on the transverse abdominals, however these three should be sufficient to get you beganAbdomen workout routines like these are key to any tummy-flattening plan, and they’re particularly good for pregnant and post-partum girls.

Associated Posts

6 Ways to Decrease your Shoulder Pain!

Continue Reading

TRAINING & FITNESS

Training to Failure Every Set… Pathway to New Muscle or Pathway to Overtraining?

Published

on

training to failure

Seven Time Mr. Olympia Arnold Schwarzenegger said in the movie Pumping Iron, “Muscle growth does not take place until the repetitions are taken past the point of failure.”  There have been many great Olympians such as Dorian Yates and Ronnie Coleman that took every set to complete muscular failure. Many people have the notion that you are not hardcore if you are not training to failure every set to complete muscular failure, and most trainers and athletes have advocated that repetition to failure is an essential characteristic of resistance training regimens.

To date there is only a single exercise study reporting training to failure may lead to greater increases in strength and hypertrophy. Two studies had caused controversy in the resistance training research realm when experimental groups were matched for total work; isometric force production, single repetition maximum strength, local muscle endurance, and explosive power gains were similar regardless of whether the sets were taken to complete muscular failure or not.  Some researchers have advocated that taking every set to total failure leads to long-term overtraining, which may be counterproductive to muscle growth. There has not been a training to failure study for some time, so researchers decided to investigate the subject once again. The purpose of the study was to compare the increases in muscular strength, size, and neural activation between three resistance training programs in which the participants always trained to muscular failure or predominantly not to muscular failure. 28 previously untrained males, who first undertook a 4-week period of standardized resistance training to muscular failure before being designated as either high or low responders, were then randomly allocated into different groups. All groups performed a 12-week resistance training program comprised of four sets with 85% of 1RM for the bicep curls, training three times per week. One group trained to complete exercise failure while the other group did not.

At the end of the study, the researchers reported that although all the groups increased muscular strength in the arms, there were no significant differences between groups. Similarly, they reported that although all groups increased muscle size in the arms, there were no significant differences between groups.

Training to Failure Increases Cortisol Production Post-Exercise

The newest study has reported that training to failure can lead to elevated cortisol levels for 48 hours after exercise. Researchers examined post-exercise anabolic effects after two resistance training (bench press and squats) workouts:

-performed either close to muscular failure, 12 repetitions to failure with 70% of 1RM

-Performed further away from muscular failure, three sets of 6 repetitions (Not to Failure)

The researchers reported that training to failure resulted in greater increases in cortisol (measured immediately post-exercise), and markers of muscle damage (creatine kinase were elevated 48 hours post-exercise). Training to failure led to a lower bar speed compared to not training to failure when measured up to 24 hours post-exercise for the bench press (65% reductions in bar speed after training to complete failure versus 26% reduction in bar speed after non-training to failure), and up to 6 hours for the squat (44% reduction after training to failure versus 20% reduction after not training to failure). Training to failure also led to a lower jump height compared to not training to failure when measured up to 48 hours post-exercise. This study shows that the mechanical, neuroendocrine and autonomic cardiovascular response is markedly different when manipulating the number of repetitions per set. Halving the number of repetitions in relation to the maximum number that can be completed serves to minimize fatigue and speed up recovery following resistance training.

Training to complete muscular failure results in increased cortisol productions and delayed muscle recuperation. If you do train to failure, then you may need to train less often or try keeping your reps lower as the study did. Based on the research, training to failure each workout may lead you on the pathway to overtraining.

Continue Reading

TRAINING & FITNESS

When Training to Failure Can Hurt You

“Training to failure resulted in greater neuromuscular fatigue and longer muscle recuperation than the not training to failure group for 48 hours”

Published

on

If you go into any gym or college training facility, you will see athletes pushing themselves to the limit. In order for an athlete to achieve greatness, he or she must push themselves to the limit, but there is a time when an athlete must pull back to avoid over training.

The body much like a race car, the body needs regular maintenance, if you hit the nitro button on the car too much, your going to burn out the engine. One of the easiest way of hitting the nitro button too much is by training to complete muscular failure each set. Training to muscular failure has been proposed to lead to greater gains in muscular strength and size because of greater neural drive when training at a closer proximity to muscular failure, implying that more motor units may be recruited.

While failure can be a valuable tool in a bodybuilder’s training routine, there is some evidence to indicate that it comes with a significant cost.

Previous research has found that training to failure every set significantly increased resting levels of the catabolic hormone cortisol and suppressed anabolic growth factors such as IGF-1. This study demonstrated that taking every set to failure could lead to overtraining and a catabolic response. This study may indicate that bodybuilders who take every set to absolute failure may put themselves at risk of impeding long-term growth.

In one 12–week study, the researchers found no difference in the routines that were taken to failure and those that were not. This study only lasted 12 weeks, so long term effects of taking every set to absolute muscular failure is not known. Training to failure too frequently can a possible lead to over training, as previously reported with the study that training to failure resulted in greater increases in cortisol and decreased IGF-1 levels. A new study published in the International Journal of Sports Medicine reports that training to failure each set needs longer recuperation than those not training to failure.

This study analyzed the time course of recovery following two resistance exercise protocols differing in level of effort: maximum (to failure) vs. half-maximum number of repetitions per set.

Researchers had a group of volunteers perform 3 sets of bench presses and squats.

Nine males performed either:

3 sets of 8 reps (80% 1RM) to failure

3 sets of 4 reps (80% 1RM) not to failure.

Training to failure resulted in greater neuromuscular fatigue and longer muscle recuperation than the not training to failure group for 48 hours. This indicates it takes a longer time for full muscle recovery following intense resistance exercise that is taken to failure compared with a similar workout where sets are terminated before failure is reached. Future studies should be conducted to determine how fatigue extent influences MUs recruitment and RT-related muscle adaptations on strength trained and untrained individuals.

Some research question the scientific validity of training to failure each set. For example, using trained participants train to failure and the other group train just short of muscular failure. At the end of the study, both group increased muscular strength and muscle mass equally, with no differences between the groups. It seems that when volume is equated between groups, it does not matter whether a person trains to failure or not to failure.

Researchers wanted to test the validity of training to failure vs. not training to failure in a series of different training methods.

Researchers had one group perform:

5 sets of 5 reps (Not Training to Failure).

25 reps in as few sets as possible (Muscular Failure).

Under both workout conditions, they had 2 minutes rest between sets (2 seconds concentric, 1 sec isometric, 2 seconds eccentric). The training load and training volume were both the same. The The training protocol to failure required ~7 minutes and 6 seconds to complete, whereas the training protocol not to failure 5×5 protocol required 12 minutes and 10 seconds to complete.

The study suggests that, when training just short of muscular failure using a 5×5 approach, may attain similar strength increases when compared to training to complete muscular failure. When volume is matched, both protocols produced the exact same increases in strength but training to failure appears a more time-efficient protocol.

“Training to failure resulted in greater neuromuscular fatigue and longer muscle recuperation than the not training to failure group for 48 hours”.

Related Article

Avoid Over-Training – When Training to Failure Can Hurt You

Continue Reading
Advertisement

Recent Posts

Advertisement

Sponsored Ads

TRENDING